|
 Unit
Testing
•
A simple test can be performed to determine the fire flow of a given
water source.
•
In addition to the TurboDraft setup, connect a master stream device
with a straight bore nozzle.
•
See page 12 to determine the estimated fire flow for your location
and required nozzle bore for deck gun.
•
Place the TurboDraft unit in operation as shown in the TurboDraft
Set-Up images.
•
Once the water supply is established, start flowing water to the
deck gun and continue to increase water flow to the deck gun until
the 5 inch line from the TurboDraft starts to get soft. At this
point you have reached the maximum flow.
•
Read the pressure at the deck gun. Refer to Chart 3 below to determine
the flow for the deck gun at that pressure.
|
